Hosted Projects - Non-FreeSpace > FringeSpace
We can 3D too...
JGZinv:
If you search around you probably have a hackerspace around you, and they tend to have
the low end personal 3D printers.
The Pegasus was printed off a Makerbot Replicator, the other two were ordered through a 3D printing service
where you get bids on what you want to make. I tried a Makerbot Cupcake before the Replicator and it's frankly a piece of trash.
Reprap is one, Makerbot another.... there are quite a few out there. The pro units are in the several thousands (USD) and up into the hundreds of thousands
to purchase. Schools and specialty businesses have them.... or Jay Leno.
z64555:
--- Quote from: JGZinv on August 22, 2012, 12:08:06 pm ---Schools and specialty businesses have them.... or Jay Leno.
--- End quote ---
Colleges and Universities, especially. I swear freshman flock to that like sheep. :rolleyes:
JGZinv:
really need to build these at 2x current scale, then the detail bits would be there
DML:
Wow, this is really cool.
Are you going to putty these, or sand and carve them prior to the painting?
JGZinv:
The pegasus one is mine, so perhaps eventually. I've got a printer now so I may experiment with some better ones.
Navigation
[0] Message Index
[*] Previous page
Go to full version