[Axem]

This is driving me insane.

I'm trying to finish up some LODs for a ship, and when I try to convert it, it tells me, "Too many polygons in the same average location."

After searching for it on the board, it would appear I need to scale it up in trueSpace and then put in a small conversion factor for PCS.

Except this doesn't work. It still give me the same error. The best I've done is narrow it down to the LOD1. I've successfully converted everything else though.

Does anyone know what else causes this error? There are no small details on this, and the only other thing I read about that could cause this is an exact copy of the mesh in the exact same spot, but I've checked that too.

EDIT: Argh. Nevermind. Problem solved.

Axem's lesson of the day: Don't leave PCS open for so long.

[Getter Robo G]

Why? What occurs if you do?

[Axem]

It seems to give off the error "Too many polygons in an average location."

I had it open for a while, along with Wings3D, LithUnwrap, trueSpace. I was going back and forth through all the programs to see what was wrong with the mesh, but restarting PCS seems to have fixed it.