I really like the new interface, and the rendering is nice and clean. However, I seem to have run into a very serious, and irritating bug.
I converted the model ncrus01, which has about 1.5k polygons. It shows up rendering properly, and I am not aware of any problems until I finish all the turret and subsystem info and then set it up for a test. FRED crashes upon seeing the model, stating "serious model error, resetting 1 normals to 1." Puzzled, I looked at it again in PCS2, with no apparent errors. I have converted many models before and never run into this problem. Upon opening it in modelview, I found that it had a NEGATIVE width. As in, a width of -717. This may or may not be related to the fact that for all normal entries, for the turrets, the default X value was -000000, while the others were just 000000. Both FRED and Freespace both crash when they see the model, and I know there aren't any geometry problems. I can send the model in question if you want.