Not bad for a slap up.
Anyway, here's some pics of the high poly Mk2. Sorry about the colors. They're mainly to show the details, sorta.
http://www.3dactionplanet.com/hlp/hosted/the158th/mik/MjolnirRef01.jpghttp://www.3dactionplanet.com/hlp/hosted/the158th/mik/MjolnirRef02.jpghttp://www.3dactionplanet.com/hlp/hosted/the158th/mik/MjolnirRef03.jpgOn the front end of the beam core, you can see, among other things, the recessed secondary launchers. They're a bit big, so maybe they should be multiple smaller launch tubes, in a staggered grid array. You can also see the starboard maintenance hatch, which allows access into the generation chamber behind the lens.
On the aft end of the RBC, there are ten 'figure-8' rectangles: five on the core, and five spread across the back end of each of the fingers of the outer grinder. These are thrusters. The ones on the core are for large scale FOV changes for the entire RBC, whilst the ones on the backs of the outer grinder fingers are for actual propulsion. You can also see the after dock point in the center of the beam core's "pommel".
In the close up shot, you get a much better view of the thrusters, and you can see that most of the back side of each of the outer grinder's fingers are taken up by thermo-dump panels.
I do hope all this helps. I swear, one of these days I have to put together a blueprint sort of render/spec sheet thing for this model.
