I made a new model for FS2 using TS1. After finishing the model I used POF2COB to convert it to POF format and Modelview32 to convert it to an FS2 POF from the FS1 POF (And don't start p1mping, Kazan, cause POFCS v.0.95 screwed up my model when I tried converting, and don't give me that **** about it not working w/ TS1, because it does.) I got it all set up, but when I tested it in Fred2 (I was using the GVA Setekh TBL entry) half of the ship didn't show up (specifically the main hull).
Here's the file so you all can tell me what I did wrong in the shortest amount of time: http://www.3dap.com/hlp/hosted/gtdwolf/x11.zip
Webmaster of GTD Wolf
Visit the GTD Wolf Forums here
Any and all Bosch Beer is hereby stolen - ahem, confiscated - by the GTVA - No, ensign, don't get out the cups yet - and must be sent to the GTD Orion Class Destroyer, the GTD Wolf - Corporal, I said we wanted pizza, not hamburgers! - stationed in this system. Any reluctance to comply and we'll make you our pinata - ahem, PoW - until further notice.